Baroque Background, Birthday, Brutus Monroe, Distress Oxides, Florals, Tim Holtz

Emboss Like A Boss!

2018-10-08 08.17.21
 Did you know Brutus Monroe has an Embossing Powder of The Month Club?!  Here’s how it works:  If you sign up for the Embossing Powder club, you will receive a unique, limited edition powder once each month.  IF there are any powders left over from the subscriptions, they will be sold in store until gone.  Also, everyone that SUBSCRIBES to ANY of the subscriptions (Stamp Club, Inspiration Box, EP), will also receive 15% off on every in store purchase at any time.
 This is ONLY if you subscribe!  That’s quite a deal!  I hope you take advantage of it!                  Now, on to my card!  On a piece of Bristol Smooth card stock which I dusted thoroughly with my anti-static powder, I stamped out the beautiful Baroque background stamp with Versamark, then heat-embossed it with rich, dark Coffee Grounds embossing powder from September’s Club.  I tapped out several distress oxide inks (Fossilized Amber, Carved Pumpkin, Fired Brick and Bundled Sage) onto my craft mat, spritzed with water, then pressed my embossed background into the watery ink, moving it around to distribute the colors, drying between each one.
2018-10-08 08.17.30
When I was satisfied with that, I set it aside to work on my sentiment die.  I cut it from  Macchiato card stock, which is beautifully heavy and luxurious! I then outlined each letter with Craft Glue and sprinkled on copper glitter.  It took several tries to get the glue to completely cover the letters, and several attempts to cover the glue with my copper glitter!   I’m bummed that it still didn’t quite cover every bit and it smudged a little onto my vellum panel.  GAH!  May I just say that my table and floor is covered though!!  😀
2018-10-08 08.17.37
I was too invested in this card to start over so I carried on!  After trimming down my background I then added a smaller layer of vellum.  I attached it with Thermoweb Sticky Strip Runner then adhered my sentiment onto it, again using Brutus Monroe’s Craft Glue.  Finally, a card base of Macchiato finished my card!
2018-10-08 08.17.50
Despite my messy glitter adventure, I still love this card and in real life, it’s absolutely stunning! Let’s take a peek at the other’s embossed wonders!!                                                                              MARIE   JESS   LAUREN   BERINA   WALESKA    HEATHER B.  
Brutus Monroe, Copics, Halloween Cards, Pumpkin Faces, Scare Crows

Pumpkin Pile

2018-09-30 12.30.36
Welcome back, friends!  I’m sharing another Halloween card which I made with Brutus Monroe’s Pumpkin Faces and a couple images from Scare Crows!  The two sets pair beautifully and I had so much fun creating this!  I began by stamping the top pumpkin first, then masked in order to stamp the next one, and so on.  Before I stamped the bottom pumpkin, I added the fence from Scare Crows, then masked that so I could pop the big ol’ punkin behind it!
2018-09-30 12.31.19
My next step was to heat-emboss the faces onto each pumpkin before coloring them with Copics.  I used the masks again to cover each one so that I could add the pale blue background with a soft makeup brush.  I also heat embossed in black the sentiment from Scare Crows directly to my panel.
2018-09-30 12.31.32
I stamped the cute little crow from Scare Crows onto the fence, then drew in some grass and flowers for a little extra interest.  When my panel was completely colored, I  spattered on some orange and black ink; the black actually appears purple so that influenced my choice of patterned paper!  I trimmed down my panel with a Stitched Rectangle die then tilted it slightly sideways onto the paper.  A white card base makes the colors pop!  If you’re interested in a versatile set of pumpkins for  your fall and Halloween cards, consider adding Pumpkin Faces to your stash!

2018-09-30 12.32.29

Brutus Monroe, CTMH Stamps, Dance With Denim, Distress Oxides, Halloween Cards, Stamp of the Month Club, Surface Inks, Tim Holtz

Bite Me!!

2018-09-29 16.35.24
Did you know that Brutus Monroe has a Stamp of the Month Club?  It’s a sweet little deal and if you’re interested in the details, click HERE!  So, how freaking cute is this vampire candy corn??  He’s this month’s image for the Club and we all loved playing with him!  My card involved some masking and stamping but was worth the extra effort!  I began with a piece of Bristol Smooth card stock and stamped my first little vampire then heat-embossed with black.  I created a mask so I could cover him up in order to stamp the second one.  Heat-embossed in black again and so on till I had filled my panel with scary little vampire’s!  In the process, I got a few inky fingerprints on my panel, but knew I’d be covering it with a layer of black ink, so didn’t sweat it!
2018-09-29 16.36.10
Next I pulled out my new Aqua Pigments and did a little color mixing since I don’t have the complete collection.  Mixing colors was easy and I can lighten or deepen my shades by the addition of water or extra ink!  I added shading to the white parts by watering down the tiniest drop of black pigment!
2018-09-29 16.36.19
To fill in my background, I had to cover the top layer of vampire’s with the masks, then using upward strokes with my sponge tool, I added Zest Surface ink to the panel.  I covered most of that with a heavy layer of Black Soot distress oxide ink, then a final layer of Raven Detail ink!
2018-09-29 16.36.49
Next I moved the masks to the bottom row of vampire’s and filled in the space below, again with Black Soot then Raven.  I used a black Zig to deepen the color below the candy corn.  BITE ME was heat-embossed in white over the black.  I enhanced the eyes and teeth with a white gel pen.
2018-09-29 16.36.56
I trimmed down my panel with Stitched Rectangle dies, then mounted it to another panel upon which I’d stamped Dance With Denim in Carved Pumpkin oxide ink!  I like the textured look of it framing my card on a black base card!  Lastly, the Trick or Treat sentiment is from an old CTMH stamp set called Thriller.  This card was pretty fun to make and I loved seeing it emerge!  Now, let’s see what the Inspiration Team has made with their Stamp of The Month!                                   HEATHER      LAUREN     MARIE    JESS

Purchase this card at my Etsy Shop!


 

Brick Wall Background, Brutus Monroe, CTMH Stamps, Distress Oxides, Fall/Autumn, Hit The Brick background stamp, Kuretake Zig Clean Color Real Brush pens, Pumpkin Faces, Tim Holtz, Unity Stamps, Water Colored Cards

Inspiration

2018-09-30 06.53.48
As a stamper and card artist, I find inspiration in some unexpected places!  Like, at the Dollar Tree!  I found this gorgeous plate there last week and just love the artists watercolor style!  I had to have it, so it came home with me!  I knew right away that I’d use Brutus Monroe’s Pumpkin Faces set to make my card; it comes with TEN various sized and shaped pumpkins plus ten faces to add on!  Now, I like scary pumpkins as much as anyone, but how wonderful that I can use this set for an elegant card!  
2018-09-30 06.53.48-1
I stamped and heat-embossed the four pumpkins in silver, masking in order to layer them.  In retrospect, I wish I’d used dark gray ink instead.  Using the plate as a guide, I colored the pumpkins with a variety of Zig markers in shades of green, gray and brown, adding water to soften the ink.  My leaves and vines are from an old CTMH set called Grapevine and I think they beautifully complement the design.  I stamped them with Bundled Sage oxide ink.  
2018-09-30 06.53.48-1-1
At this point, I realized that Brutus Monroe’s Hit The Brick background would go perfectly so I inked it up with Bundled Sage oxide and gently maneuvered the stamp to fill in the space above the pumpkins.  That’s the beauty of flexible cling stamps!  I trimmed my panel with a Stitched Rectangle die then mounted it to a panel of dark gray.  On a piece of vanilla card stock, I stamped more of the vines and leaves with Bundled Sage again and attached it to a base card of Jurassic card stock.  
2018-09-29 08.57.24
When my card was complete, I made a coordinating envelope with more vines and leaves.  I’m pretty happy with my card and hope you like it too!  Now, I’m off to Dollar Tree to buy more of these plates!  And you should head straight to Brutus Monroe to check out these pumpkins!  😀
Brick Wall Background, Brutus Monroe, Christmas, Distress Inks, Distress Markers, Distress Oxides, Distress Resist Spray, Emboss Resist Technique, Hit The Brick background stamp, Holiday Greens dies, Lunchbag 100lb cover cardstock, Surface Inks, Tim Holtz, Unity Stamps, Water Colored Cards

Cozy Country Christmas

2018-09-26 12.12.28 (1)
Can I just say I’m in love??!!  I’ve been playing with my spankin’ new Unity/Brutus Monroe Hit The Brick background stamp and having SO MUCH FUN!!  I have so many ideas of ways to use this one!  Yesterday I laid out three panels of watercolor card stock, then covered my Brick stamp with a heavy layer of Ranger’s Distress Resist Spray and stamped it onto the stock.  The card above is the first one I did, and the spray was so saturated on the stamp that it lost some of it’s detail.  The second one was a better image and the third one was perfect!  BUT!  There was no way I was going to waste this one and here’s what I made!
2018-09-25 08.47.26
So, here are my three panels after stamping out the Hit The Brick background, as mentioned above.  Not a great picture but you get the idea!
2018-09-25-08-51-24.jpg
I sponged on these colors: Suede Surface ink, Terracotta Surface ink and Walnut Stain Distress Oxide.  The Resist Spray is VERY resistant so the shiny parts didn’t take the ink very well.
2018-09-25 08.52.30
My finished panel; I didn’t love it but was hopeful I could make something beautiful with it!
2018-09-26 12.13.34 (1)
I decided to cut out the center of my panel with Oval Stitched dies and create a “window”~ but what to place in my window?  After trying out several stamps, I settled on this one by Stampendous called Cozy Cottage which I stamped on a separate piece of Bristol Smooth watercolor paper using Gathered Twigs Distress ink.  I then “painted” over the lines with a watery brush to create the soft sepia look and added a little color using Distress Markers.
2018-09-26 12.11.45
Then I realized that this would make a great shaker card!  I’ve only made a few with much angst and frustration, but this one came together beautifully!  I attached a piece of acetate to the backside of the window, then built a wall of foam tape going all around the back of the sponged panel to hold in the “snow” which is actually Ultra Thick Clear Embossing powder!!  I added a few sequins and micro beads as well!  Can you see them?  Anyway, I got all the pieces and parts in the correct order and voila!  A shaker panel!
2018-09-26 12.12.03
I found the perfect patterned paper to attach the panel to, then mounted it to a card base of Brutus Monroe’s Lunchbag card stock!  The final touch was a few sprigs of Tim Holtz’ Holiday Greens holly touched up with a bit of Gathered Twigs distress oxide ink and three little “berries”!   Now, isn’t this a lovely scene framed by that amazing Brick background?!
INSTABRUTUS
Unity is still holding their awesome giveaway!  You have until October 1st to comment on any of the blogs which participated in the blog hop for a chance to win!  Here’s the link to their blog with the lineup!  On October 2nd, they’ll choose the lucky winners!  I hope it’s you!!  

 

Brutus Monroe, Distress Oxides, Distress Resist Spray, Florals, Hit The Brick background stamp, Hollyhocks, Surface Inks, Tim Holtz, Unity Stamps

Unity Hollyhocks Hit The Brick

2018-09-25 08.47.26
Happy Saturday, friends!  It’s my day to share on the Brutus Monroe blog and we’ve had an exciting week with our recent reveal of the Unity Stamps and Brutus Monroe collaboration!  I received the Hit The Brick background stamp and paired it today with Unity Stamps Hollyhocks!  Above are pictured three panels which I created using the Brick background and Ranger’s Distress Resist Spray on watercolor card stock.  The first panel had the most spray so left a smudgy impression but I kept stamping it out onto the next two panels and got a better impression with each one.  You can be sure I’ll use them all, though!  
2018-09-25 08.58.06
On the second panel, I sponged a layer of Zest Surface ink onto the center and then surrounded it with a layer of Sea Surface ink.  Isn’t that textured brick background gorgeous?!  
2018-09-25-09-08-10.jpg
Next I inked up Hollyhocks with black embossing ink, stamped it onto my panel then heat-embossed with black powder.  I over-stamped another layer of the Hollyhocks with Iced Spruce distress oxide ink.  
2018-09-25 09.11.17
My sentiment is from Unity Stamps Tess Girl set and I heat-embossed it in black directly to my card front.  When I added the black embossing powder, bits of it stuck to my Iced Spruce Hollyhocks but I decided to leave the residue as it gave another cool textured element!  
2018-09-25 09.16.42
I decided to trim down my panel with Stitched Oval dies, making a slightly larger black oval to frame my main panel, and then stamped the Hollyhocks again onto a white base card with the Iced Spruce oxide ink.  
2018-09-25 09.23.30
I adhered all the pieces together and this is my finished card!  
2018-09-25 09.23.13
I love how the two stamps, Hit The Brick and Hollyhocks paired so beautifully and the pop of Zest is so striking!  There are four new background stamps made for Unity/Brutus Monroe so be sure to check them out!  Here are the links:                                                                                               Hit The Brick     Dance With Denim      Barn Wall      Spilled Paint